Weatherby Mark V Capra Ti 6.5 Weatherby RPM 21-inch
Video review
Expert review
About this product
The Weatherby Mark V Capra Ti 6.5 Weatherby RPM 21-inch is a factory-built bolt-action hunting rifle engineered for extreme backcountry mobility without sacrificing terminal ballistics. It combines a Grade 5 titanium receiver and fluted barrel with Weatherby's proprietary RPM cartridge family. This is not a general-purpose rifle; it is a specialized tool for hunters who measure success in ounces saved and miles covered.
What is the Weatherby Mark V Capra Ti used for?
This rifle is designed for high-alpine and backcountry hunting pursuits where every ounce matters over multi-day stalks. It is a purpose-built platform for the 6.5 Weatherby RPM cartridge, which drives high-BC bullets at velocities that extend ethical shot placement beyond traditional 6.5mm cartridges. The 41.25-inch overall length and 4.40-pound bare rifle weight make it manageable in tight timber or when scrambling over rock, and the threaded, fluted 21-inch barrel is ready for a direct-thread suppressor without adding excessive forward weight.
How does the Weatherby Mark V Capra Ti compare to the Stevens 334 Rifle?
The Capra Ti is a dedicated lightweight hunting rifle, while the Stevens 334 in .308 Win is a budget-conscious, general-purpose hunting tool. The Capra Ti is better at cutting weight, using a titanium receiver to achieve a 4.40-pound weight versus the Stevens 334's approximately 6.5-pound synthetic stock configuration. Conversely, the Stevens 334 is better for cost-conscious hunters who prioritize affordability and common ammunition (.308 Winchester) over exotic materials and specialized, premium-priced cartridges like the 6.5 Weatherby RPM.
What does it weigh and what are the dimensions?
The rifle has a listed weight of 4.40 pounds (70.4 ounces or 1,995 grams) and an overall length of 41.25 inches. The barrel is 21 inches long with a 1:8-inch twist rate, and the magazine is a fixed, low-profile design with a 2+1 capacity. The titanium receiver's weight savings are critical, shaving nearly a full pound compared to a comparable steel action. This specific configuration results in a balance point approximately 3 inches forward of the trigger guard when scoped, which aids in off-hand shooting stability.
Who is this NOT for?
This rifle is not for the first-time hunter, the recreational plinker, or anyone sensitive to premium ammunition costs. The 6.5 Weatherby RPM is a proprietary, low-production cartridge that costs roughly $4.50-$6.00 per round for factory loads, making sustained range time prohibitively expensive. It's also not ideal for benchrest precision shooting where a heavier, stiffer barrel is preferred, or for hunters who prioritize a higher ammunition capacity over ultimate weight savings.
What's in the box?
The rifle ships from Weatherby with the Accubrake muzzle device installed, one two-round magazine (for a total 2+1 capacity), and the factory paperwork. It does not include scope mounts, rings, a sling, or a case, which are necessary additions that will add 1.5 to 3 pounds to the total carried weight. The receiver is drilled and tapped for standard #8-40 scope base screws, requiring the hunter to source their preferred mounting system.
Is the Weatherby Mark V Capra Ti worth it at $3,261.99?
At this price, it is worth it only for the specific hunter whose primary constraint is pack weight and who demands a rifle capable of shots beyond 400 yards in variable mountain conditions. You are paying for the material science (Grade 5 titanium), the proprietary cartridge performance, and the integration of a premium TriggerTech trigger. If your hunting consists of stand hunting from a blind or shots inside 250 yards, a rifle like the Stevens 334 in .243 Win at one-fifth the cost is a far more rational financial choice.
Specs at a glance
Pros & cons
What works
- Weighs 4.40 lbs (1,995g) — critical for multi-day alpine hunts where every ounce counts.
- Titanium receiver shaves nearly 1 lb versus a steel Mark V action without sacrificing tensile strength.
- Includes a premium TriggerTech trigger with a consistent 2.5-4 lb adjustable pull weight out of the box.
- 21-inch fluted, threaded barrel is optimized for suppressor use without excessive overall length.
Trade-offs
- Proprietary 6.5 Weatherby RPM ammunition costs $4.50-$6.00 per round, making practice expensive.
- Fixed 2+1 magazine capacity is limiting for any application beyond deliberate hunting shots.
- No included scope mounting solution; adds $80-$200 and 6-10 ounces for a proper rail and rings.
- The lightweight design transmits more felt recoil than a heavier rifle in the same caliber.
Key attributes
| upc | 747115462643 |
| manufacturer | Weatherby |
| manufacturer part number | MBP01N65RWR3B |
| action | Bolt Action |
| barrel length | 21" |
| caliber/gauge | 6.5 Weatherby RPM |
| capacity | 2 + 1 |
| safety | Two-Position |
Frequently asked questions
- Is the barrel threaded for a suppressor?
- Yes, the 21-inch barrel is factory-threaded 5/8x24 TPI. This is the standard thread pitch for .30-caliber muzzle devices and direct-thread suppressors. You can mount a suppressor or a different muzzle brake without requiring a gunsmith, provided the device is rated for the 6.5 Weatherby RPM's chamber pressure.
- Does it come with a scope mount?
- No, the rifle ships without a scope mount or rings. The receiver is drilled and tapped with a standard Weatherby Mark V bolt pattern, requiring a separate purchase of a Picatinny rail or direct-mount rings. I recommend using a one-piece steel base from a reputable manufacturer like Warne or Leupold for maximum stability under recoil.
- Can I use 6.5 Creedmoor ammunition in this rifle?
- Absolutely not. The 6.5 Weatherby RPM is a proprietary cartridge with a significantly larger case head and overall cartridge dimensions than 6.5 Creedmoor. Attempting to chamber a Creedmoor round will result in a failure to fire and a potentially dangerous extraction issue. You must use factory-loaded 6.5 Weatherby RPM ammunition or hand-load using specific Weatherby RPM brass.
- How long does shipping take to an FFL?
- For an in-stock item like this, processing and shipping typically take 2-3 business days from order verification. The firearm will ship via a contract carrier with adult signature required. The total transit time to your chosen Federal Firearms License (FFL) holder depends on your location, but it is generally 3-7 business days. Your FFL will then contact you to complete the Form 4473 background check before transfer.